Clear Coating in three finishes - Hi-Gloss - Semi-Gloss - Satin
Navigate: Our Site
MARBLE-EMULATION Coating is
produced in two distinctive formats, a single
component and a two-part Nano Technology
"0" VOC aliphatic polyurethane enamel that forms a uniquely hard and durable coating film. This self-leveling coating is resistant to water, acids, solvent and impact.
is a system. MARBLE-EMULATION
can be applied to metal, concrete, masonry,
wood and many other substrates UV
control, anti-microbial, anti-graffiti, or
simply a tough clear coating to enhance and
beautify any surface.
As a topcoat:
Will protect longer and cost less
Surface must be clean and free of dirt, oil, tar, grease, salts and residue.
Surface must be completely dry before applying.
must be applied
in multiple coats to meet any thickness
If applied over an existing coating and this coating is glossed, it must be sanded and roughed before application,
high gloss. Can be applied as a one-coating system for (graffiti protection in clear finish only).
Open pail, mix base with curing agent.
Mix by hand for two minutes.
If below 70F. degrees, allow to stand for
Begin application; During summer months, apply the coating in the morning or after
Four hours at 70F. degrees; one hour at 90F. degrees, once base and curing agent have been mixed.
You will swear is MARBLE
Product Application and Handling
can be applied by brush, roller or spray;
If application is by brush, use a soft bristle brush.
If application is by roller, use a
1/8 inch nap roller. Use a brush to remove any trapped air bubbles, if any.
If application is by spray, use a standard airless sprayer (2,800 psi or less) with a .024 tip.
NOTE: The number of coats and the thickness of each coat will be in accordance with the job specifications.
Minimum Spread Rates:
Porous surfaces Apply in 2 coats at 200 sq.ft. per gallon, each coat (8 mils wet) - (3.67 mils dry) Non-porous surfaces -- Apply at 250 sq.ft./gallon ( 6.5 mils wet)
Stir product thoroughly before using. MARBLE-EMULATION
can be applied by brush, roller or spray equipment. It should be applied evenly without buildup. Apply in a 2-coat application system. CAUTION: Wear gloves and protective clothing.
Wear eye protection. WATER: Clean-up or reduction, clean equipment before breaks (lunch hour)
or at conclusion of job.
One hour to touch at 70F degrees.
Over coating window is three hours at 70F. degrees or longer.
Fully cures in ten days.
If temperature is over 90F. degrees, cure time and pot life is shortened to 1 hour.
Apply between 40F. and 120F. degrees.
Store between 40F. and 120F. degrees according to hazmat standards indicated on MSDS.
During breaks, spray systems should be flushed with
After completion, spray systems should be flushed and cleaned with
After completion, brushes and rollers should be cleaned with